iCOB 15 W/m Free-Cut LED Strip

iCOB 15 W/m Free-Cut LED Strip

A continuous, dot-free COB LED strip for indoor use. This is the Free-Cut version: it can be cut anywhere, so you can get any length you want. 10 mm wide, 15 W/m at 24 V DC, with colour rendering of Ra 90 or better.

[IMAGE PLACEHOLDER – cut-anywhere image]

Specifications

Colour options

Installation guide

1. Check the code, colour and that your driver is a 24 V DC constant-voltage LED driver.
2. Fit indoors in dry spots only (IP20). Stick it to a clean, dry, smooth surface; an aluminium profile is recommended.
3. Cut anywhere along the strip with sharp scissors, square across the strip.
4. Peel the 3M adhesive liner and press the strip firmly into place. Don't fold the strip sharply.
5. Wire each strip back to the driver in parallel. Match + and − to the marks on the strip.
6. Have a licensed electrician wire the driver to mains, then check polarity and switch on.

FAQs

Where can I cut it?
Anywhere. It's the Free-Cut version, so you can get any length you want.

Will I see dots?
No. It's a COB strip with no light spot.

Can I use it outside or in a bathroom?
No. This strip is IP20, for indoor dry locations only.

What power supply do I need?
A 24 V DC constant-voltage LED driver. The strip uses 15 W/m.

How long can a run be?
Up to 10 m at 24 V, fed from one end.

Can I dim it?
Yes, it's dimmable.

What's the warranty?
3 years.

Download the spec sheet (PDF)